Product Help

Air Purifier

Air Purifier P1

Evaporative Humidifier

Evaporative Humidifier 2

Standing Fan 2s

Standing Fan 3

Fan Heater

Convector Heater 1s

Smartmi VortexWave A1

The robot itself has a radar protection function. When the radar is damaged or blocked, the robot will alarm and stop working, and the danger needs to be removed manually. Note: When the voice broadcast of radar-related abnormalities, please check whether the radar mask is stuck by foreign objects, whether the radar is blocked, and move to a new position to start.
The robot is equipped with a cliff detection sensor, which can prevent the robot from being injured and damaged by falling from stairs and steps higher than 8cm when cleaning. When the cliff sensor fails or is obscured by dirt, the robot will alarm and stop working.
When the robot cleans the entire image, the single cleaning area is less than 4 square meters (the actual cleaning area of the robot), or the cleaning time is less than 10 minutes, the area will be automatically recognized as a key cleaning area, and the “well” cleaning will be performed, that is, two The 90-degree bows are clean .

The robot has two kinds of air-drying functions, namely, the robot air-drying and the charging base air-drying.

Robot air-drying function: After the roller brush self-cleaning in the scrubbing mode , the robot automatically performs the roller brush air-drying task for 8 hours (using the internal waterproof fan), and the air-drying stops when the time is up. Note: After the roller brush is self-cleaning in dry sweeping mode , the brush air-drying task will not be performed. When the robot is cleaned, it will be recharged with low power. After charging , it will continue to scan at breakpoints. This charging process does not perform air-drying tasks.

Air-drying function of the charging base: The robot charging base has an intelligent roller brush recognition function. When the charging base recognizes that a roller brush is installed, the charging base automatically performs a 12-hour air-drying task on the roller brush (the charging base has a built-in small fan). Air drying stops.

In the scrubbing mode, the brush rotation speed of the robot is 800rpm, 1200rpm and 1600rpm in the light dirt, standard and heavy dirt gears respectively.

In the dry sweeping mode , the brush rotation speed of the robot is 500rpm, 800rpm and 1200rpm in each gear of light dirt, standard and heavy dirt respectively.

the suction port of the robot in the dry sweeping and scrubbing modes is 2000Pa, 3000Pa, and 4000Pa in the light dirt, standard, and heavy dirt gears respectively.

of the robot during cleaning is about 62.7db (A) .

The robot is equipped with a sensor along the wall, which can ensure that the robot keeps about 15mm from the wall when cleaning along the wall without colliding and damaging the wall; when the robot is cleaning along the wall , the ground within 6cm from the wall cannot be cleaned.
In the case of an existing map, if the robot is picked up and put down and the APP restores the map operation, the robot will relocate to determine the location of the robot. During the relocation process, the robot will rotate around itself to recognize the surrounding environment and try to find the robot's position. If the information is insufficient, it will walk 1m to collect information and continue to try to locate.
Please make sure that the charging base and the robot charging stage are not dirty; please make sure that the charging base is connected to the power supply; please exclude the poor contact caused by the influence of foreign objects, and you can try to manually reposition the robot.